Optical Comparators have utilized the same antiquated part holding devices for many years without any improvement or development, until now

Modular fixture plates have become a standard accessory for any Quality Control lab, primarily on the CMM. A modular plate and component kit allows for fixtures to be created for a variety of parts within minutes. 

Below is the latest kit to allow you to start saving time and accurately hold a wide variety of parts on your comparator. Finally a new, better way!

The plates listed below are Anodized Aluminum with T-Slots to make for very easy and flexible set-ups. The slot rails are laser etched with scale increments for easy position replications. The T-Slots are also laser labeled for quick & simple part set-up sheet creation.